![]() ![]() Slowly feed the cable into the overflow drain while rotating the drum clockwise. Remove 6 to 8 inches of cable and tighten the wingnut again. It is most likely a hand turned wing nut which will allow you to pull additional cable from the drum of the auger or return the cable to the drum. Step 2: Insert the Drain Snake Cable Into the Drainīegin by releasing the cable locking mechanism on the front of your drain snake. Read Also > What Are The Top Acrylic Alcove Bathtubs? Pull the entire mechanism out of the tub and set aside. If your overflow drain has a switch or other mechanism on the front that allows you to raise or drop the stopper in the drain you will need to carefully remove the entire mechanism by lifting up and gently rocking or rotating the cover until it is free.Īvoid using excess force as some of the connections within this sort of plug system can be bent and make it difficult to reassemble. This will be removed with either a Philips or Flathead screw in the center of the disk, or two small screws on the front of the cover. It is usually a 2-3 inch silver disc with an opening at the top or bottom to allow water to enter. This cover will be located between the faucet and the drain in the bottom of your tub. The first step is to remove the overflow drain cover from your bathtub. Rotate the Snake Cable To Remove the Clog.Insert the Drain Snake Cable Into the Drain.How To Unclog Bathtubs With Snakes? (4 Steps) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |